Download video: Goodluckbuy Brushless Gimbal with Tilt Control

Channel: Kitty


TIP: Right-click and select "Save link as.." to download video

Initializing link download... Initializing link download.....

GLB brushless gimbal, flashed with brugi firmware r77
Works really good with manual tilt control.

How to get manual tilt: This instruction works with either the stock FW and the BruGi FW. Make sure that your gimbal is NOT connected to any POWER before attempting to do this. (Applies to DJI Naza FC owners only)
1. Remove the +(pos) lead from gimbal's three tilt control wire.
2. Connect the tilt control wire to Naza's F2 port.
3. Power ON the Naza and connect to PC, then OPEN naza assistant software.
4. Enable the gimbal option thru the naza software and power ON the gimbal(red and black wire noddles via separate 3s lipo or via the main quadcopter's 3s lipo battery by soldering the noddles on the main copter's power distribution board/wires).
5. Assuming you already programmed your RC Tx to have X1 as tilt. You should now be able to manually control the gimbal's tilt without any further modification. Enjoy and Cheers!

OPTION: Pls watch Gavin Yeo's video on how to update your firmware(read the description for instructions). Pls pay close attention to the position of your IMU sensor (usually located on the bottom of your gimbal's tilt frame).